How to show the hyperlink command in the status line?
Posted: Fri Feb 12, 2016 5:26 pm
In BlackBox I can create hyperlinks by writing
<InfoCmds.Start('http://community.blackboxframework.org/')>BlackBox Component Builder Forums<>
select the line and use the menus Tools -> Create Link.
It is shown as
BlackBox Component Builder Forums
When I point with the mouse on this hyperlink I would like to see its command in the status line:
InfoCmds.Start('http://community.blackboxframework.org/')
and the hyperlink itself should by underlined
BlackBox Component Builder Forums
How to implement this task.
Thank you very much for any help.
- Helmut
<InfoCmds.Start('http://community.blackboxframework.org/')>BlackBox Component Builder Forums<>
select the line and use the menus Tools -> Create Link.
It is shown as
BlackBox Component Builder Forums
When I point with the mouse on this hyperlink I would like to see its command in the status line:
InfoCmds.Start('http://community.blackboxframework.org/')
and the hyperlink itself should by underlined
BlackBox Component Builder Forums
How to implement this task.
Thank you very much for any help.
- Helmut